Difference between revisions of "Use Wemos D1 Mini with broken UART"
Jump to navigation
Jump to search
| (One intermediate revision by the same user not shown) | |||
| Line 6: | Line 6: | ||
</source> | </source> | ||
* To flash, use Arduino IDE, set baud rate to 115200 | * To flash, use Arduino IDE, set baud rate to 115200 | ||
| + | * Click upload in IDE | ||
| + | * Press reset | ||
| + | * Wait until flash is complete. D3 can remain connected to ground (but should not be necessary). | ||
| + | |||
| + | == Minimal config to flash bare esp8266 module: == | ||
| + | * Gnd | ||
| + | * Vcc | ||
| + | * pull up Enable / CH_PD | ||
| + | * pull down Flash (GPIO0) | ||
| + | * pull down GPIO15 | ||
| + | * Connect via ground, rx, tx | ||
Latest revision as of 15:01, 18 June 2023
- Connect using external USB - UART converter: ground, 5V, RX, TX
- Connect D3 (flash) to ground
- To erase:
python3 -I ~/.arduino15/packages/esp8266/hardware/esp8266/3.0.2/tools/esptool/esptool.py -p /dev/ttyUSB0 --chip esp8266 --before no_reset --baud 74880 --trace erase_flash- To flash, use Arduino IDE, set baud rate to 115200
- Click upload in IDE
- Press reset
- Wait until flash is complete. D3 can remain connected to ground (but should not be necessary).
Minimal config to flash bare esp8266 module:
- Gnd
- Vcc
- pull up Enable / CH_PD
- pull down Flash (GPIO0)
- pull down GPIO15
- Connect via ground, rx, tx